US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 User Manual download pdf (Page 48)

56K Softmodem

Command Reference

- 42

Table 3-73: +EFRAM Extended Syntax Commands

+ER=<value>—Error Control Reporting

Use this command to turn on or turn off the error control report. If the compression

report is enabled, the +ER:<type> intermediate result code reports the current

DCE-DCE error control type. It is issued after the determination of the error

control protocol and before the final result code (e.g., CONNECT). Specifically,

the +ER intermediate result code is issued after the modulation report (+MCR and

+MRR) and before the data compression report (+DR).

Result codes:

OK if <value> = 0, 1.

ERROR if <value> does not equal 0, 1.

Command Description

+EFRAM=<value 1>,<value 2> Sets the link-layer frame fields size.

+EFRAM? Displays the current maximum link-layer frame field size settings.

+EFRAM=? Displays the supported maximum frame sizes.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 107 108

No comments

US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 User Manual Page 48