US Robotics USR8700 User's Guide download pdf (Page 121)

Serial ATA 4-Drive NAS

User Guide

Protecting Local Disks - 119

19. When the completion screen appears, review the results and do one of the following:

20. When the computer restarts, use the appropriate procedure for your system to configure the computer

to boot from the local hard disk once more.

21. Start DiskSafe Express and remove protection from the recovered disk or partition (as described in

“Removing Protection” on page 122).

Since the computer is disconnected from the network, you might see messages about the backup

being offline. This is normal.

22. Restart the computer.

23. Protect the recovered disk once again (as described in “Protecting Your Disks” on page 98).

Recovering a System Disk While Booting Remotely

If your computer meets the prerequisites, you can remotely boot it from a backup on your storage system

and recover your system disk or partition. You can recover only your most recent backup.

Prerequisites

Before you can recover a disk while booting remotely, the following criteria must be met:

• The computer that you are remotely booting must be in the same subnet as the storage system.

• Remote boot must be enabled for that computer (as described in “Enabling Remote Boot” on

page 110).

To do this Do this

Review information about any sectors that

were not successfully recovered

Select Failed Sectors, review the displayed information, and

select Back.

Recover another disk or partition Select Continue.

If you need to recover a different backup of the same computer

from the same

storage system, select Yes to retain the current

configuration settings and return to step 10.

If you want to recover a different computer’s backup, or if you

need to recover a backup of the same computer from another

storage system, select No to modify the current configuration set-

tings and return to step 5.

Restart the computer Select Finish.

Note: If you replaced the original hard disk, the new disk must be at least as large as the original disk.

The system to which you are recovering the data must be identical to the original system. For

example, if the original system had a particular type of network adapter, the system to which you

are recovering the data must have the exact same type of network adapter. Otherwise, the

recovered files will not operate properly.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 155 156

No comments

US Robotics USR8700 User's Guide Page 121