US Robotics USR8700 User's Guide download pdf (Page 21)

Serial ATA 4-Drive NAS

User Guide

Getting Started - 19

If the System Initialization page appears, you need to initialize your disks:

If not all the hard disks have been detected, or if you want to add, remove, or reorder the disks at this

time, insert or remove the disks one at a time and click Scan after each action. If you are adding disks,

be sure to wait until the Disk LED is blue before you click Scan.

3. Click Browse and locate the USRobotics Installation CD-ROM.

4. Open Firmware\fs-usr-1.2-b609.pkg.

5. On the System Initialization page, click Upload.

The firmware on the storage system’s internal flash memory is uploaded to the hard disks.

Note: USRobotics strongly recommends that you install all the hard disks that you want to

use in the storage system at this time, since changing the number of hard disks later

can require disk reconfiguration and possible data loss.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 155 156

No comments

US Robotics USR8700 User's Guide Page 21